The SaniVITE laundry pump is a system that is used to install a kitchen or laundry room up to 16 feet below the sewer line, or even up to 150 feet away from a soil stack.

This laundry pump unit is a gray water pump ideally suited for use in a basement apartment or anywhere else in the house where additional fixtures are desired. It will pump waste water away from various sources, such as the kitchen sink, laundry sink, washing machine (indirect connection), dishwasher, bar area, etc.

The SaniVITE model was designed to sustain the toughest applications meant for gray water pumps. Its pumping capabilities and unique design are the reason why this range of pumps is preferred for heavy-duty applications.

The SaniVITE by Saniflo sink, shower, bath, washing machine, and dishwasher are perfect for both residential and commercial applications. This laundry pump unit is compatible with laundry tray pumps, air conditioning condensate, dehumidifier water removal, garbage disposal and more.

Warranty:

• 2-Year Full Manufacturer Warranty
• Extended4-Year Warranty with Product Registration (www.Saniflo.com/Register)

The inside of the SaniVITE laundry pump is comprised of a pressure chamber, which starts and stops the unit, and the motor, which drives the pump. When water enters the SaniVITE, a micro switch in the pressure chamber activates, which in turn starts the motor. The motor is sealed for life in an oil-filled enclosure. A spindle/shaft drives the impeller, and therefore, the moving parts are kept to an absolute minimum. Water enters the chamber and is pumped away into the sanitary sewer.

The unit pumps the effluent upward to 16 feet and/or 150 feet horizontally (with gravity fall). Once the water is discharged and the water level in the container goes down, the micro switch deactivates the unit until water enters the unit again. A normal operating cycle can be as short as 2–10 seconds depending upon the discharge pipe run configuration; power consumption is therefore kept to a minimum.

In addition to a sink, the laundry pump will also accept and discharge wastewater from a variety of other sanitary fixtures, such as a shower, a bathtub, a urinal, and a whirlpool. When adding a bathtub or shower, a base will have to be constructed. This base should be 2" x 6" (minimum) or 2" x 8" (recommended) on edge to allow for the installation of a P-trap and the required 1/4" per foot gravity flow toward the laundry pump unit.

Wastewater from other sanitary fixtures is discharged into the unit via two 1-1/2-inch inlets on either side of the housing and an additional inlet on the top of the unit. Depending on the discharge pipe installation, the discharge elbow on top of the SaniVITE laundry pump can be turned either to the left, to the right, or toward the back. A non-return valve, which comes already assembled on the discharge elbow, prevents backflow into the unit.

The Saniflo SaniVITE pump has been designed with a vent connection on the lid. All plumbing codes require a connection to a vent system. Please note that the vent system should be a two-way air vent. The use of mechanical vents, air admittance valves, or similar devices are not permitted, as these are considered one-way air vent systems.

This Saniflo sink pump is small enough to fit comfortably inside a kitchen cabinet or vanity or inside the overhang of a whirlpool. It is also highly recommended that the gray water pump to be connected to a ground fault interrupter (GFI) circuit.

Plumbing Code Certified:

This pump has been certified to American and Canadian standards. Electrical standard UL 788, CA: Electrical standard CSA C22.2.